How to Fit Your Audible Bark Collar
The collar needs to be properly fit to your dog. The sensor must sit on your dog’s vocal chords to detect a bark.
Your dog’s neck should be clean prior to fitting, and each time using the collar, to prevent irritation. If irritation is seen, discontinue the use of the collar until the irritation is gone.
Ensure that the collar is powered off by checking that the light is not flashing.
If the collar is powered on, press and hold the power button until a red light is seen and the collar beeps.
Center the sensor on your dog’s neck while your dog is standing.
Buckle the strap. The collar sits high and snug on your dog’s neck.
Check that one finger fits between the sensor and your dog’s neck.
Avoid leaving the collar on the pet for more than 12 hours per day to prevent skin irritation. If redness or irritation is observed, discontinue use of the product until the skin no longer appears irritated.
Adjust the Strap
Slide Buckle
Fasten Buckle
To loosen
Slide the strap down through the slide, fasten buckles and pull down.
To tighten
Slide the strap up through the fasten buckle and pull through the slide buckle.
Fasten
Once the collar has been adjusted, thread the end of the strap through the slide buckle to avoid the strap from loosening.
Identify the excess strap past the slide buckle. Loop the excess strap over the first hole on the slide buckle and through the second hole.
Pull the strap fully through the slide buckle.
Trim Strap (Optional)
If there is excess strap after adjusting and fastening the collar, trim the strap. Leave extra room on the strap if your dog is young or grows a thick winter coat.
Place the collar on your dog, and mark the strap at least 2 inches past the buckle.
Remove the collar and cut at the mark.
Contact Customer Care
If you need further assistance, please contact our customer care team.