Troubleshooting Your Outdoor Bark Control
If your dog is not responding to the ultrasonic tone or there is no light on the birdhouse, follow the instructions below to get the birdhouse working properly.
Confirm Proper Placement
To ensure there is no signal interference, make sure that the birdhouse is:
Facing the area the barking occurs
No more than 5 feet off the ground
Not near any large obstacles
Place the birdhouse in the desired location. It can be hung, mounted, or placed on a flat surface.
Confirm Power
Remove the battery door on the back of the birdhouse and dispose of the battery.
Connect a new 9-volt alkaline battery to the battery terminal and insert into the compartment.
Replace the battery door.
Test Activation
Enable test mode by turning the knob to T.
Hold the birdhouse at arms length, so that the front is visible. Make a loud noise and watch for the light to flash red and listen for a beep to confirm the sound was detected.
If the unit powers on, and your dog is not responding, ultrasonic bark stimulation may not be the appropriate solution for your dog. Contact our Customer Care for further assistance with bark control solutions.
Contact Customer Care
If you need further assistance, please contact our customer care team.